Audi Q7 2007 Repair Manual page 326

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
12 - Vents
13 - Evaporator Housing Upper Section
Note
From 11/2007, the "Comfort" A/C
system as an updated Fresh Air
Blower Control Module - J126- (an
updated "Comfort" Climatronic Con‐
trol Module - J255- and an updated
Fresh Air Blower - V2- ). An updated
evaporator housing upper section is
also being used. Make sure to use
the correct allocation for these parts
with each other. Refer to
⇒ "9.31 Fresh Air Blower Control
Module J126 , Removing and Instal‐
ling", page 164
alog.
14 - Clips
15 - Bolt
18.5.2 Foam Seal on Evaporator, Checking
– Check the applied foam seals -B- to -D- for damage and proper
bonding before inserting evaporator
– Place seal -A- (for seal of both evaporator refrigerant lines on
evaporator housing) on to evaporator pipes.
18.5.3 Evaporator into Lower Section of Evap‐
orator Housing, Inserting
– Insert the evaporator -A- first into evaporator housing accord‐
ing to the illustration, pay attention to perimeter seal -arrows-
while doing this.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
320
Rep. Gr.87 - Air Conditioning
and to the Parts Cat‐