Audi Q7 2007 Repair Manual page 291

– Position the Engine Support Bridge - 10-222 A- with Adapters
- 10-222 A/22- and connectors - T40091/3- on to bolted flang‐
es of fender.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install the remaining parts of the Engine Support Bridge -
10-222 A- as shown in the figure. Position the Adapters -
10-222 A/19- on the seam of the longitudinal member (be
careful of the refrigerant lines on the longitudinal member
when doing this).
– Hang the hooks of the short Spindle - 10-222 A/10- into the
left rear engine lifting eye.
– Slide the Support - T40091/2- using Slider - T40093/5- into
both Connectors - T40093/4- .
– Assemble the long spindle from Engine Support Bridge -
10-222 A- and hang the hook of the spindle into the left front
engine lifting eye.
WARNING
Secure the Support - T40091/2- using stud and cotter pins of
Connector - T40093/4- .
– Pre-tension the engine by uniformly tightening both spindles.
– Remove guide for oil dipstick.
– Remove the supply pipe to power steering system. Refer to ⇒
Suspension, Wheels, Steering; Rep. Gr. 48 .
– Disconnect the coolant hose -arrows-.
– Loosen the left coolant hose and remove associated hose
from coolant regulator. Refer to ⇒ Engine Mechanical; Rep.
Gr. 19 .
16. Compressor, Removing and Installing (Vehicles with 8-Cylinder Engine and 12-Cylinder TDI Engine)
Heating, Ventilation and Air Conditioning - Edition 04.2013
Audi Q7 2007 ➤
285