Audi Q7 2007 Repair Manual page 336

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
Note
For removing and installing the rear A/C unit, refer to
♦
⇒ "19.3 Rear A/C Unit, Removing and Installing", page 325
Attachments, removing from A/C unit and re-installing. Refer
♦
to
⇒ "20.1 Attachments, Removing from Rear A/C Unit and In‐
stalling", page 327 .
1 - Bolt
2 - Heater Core Cover
3 - Rear Heater Core
❑ For removing and instal‐
ling with the A/C unit in‐
stalled, refer to
⇒ "9.40 Heater Core,
Removing and Instal‐
ling, Rear A/C Unit In‐
stalled", page 182
❑ Bonded foam seal,
check before installing.
Refer to
⇒ "9.40 Heater Core,
Removing and Instal‐
ling, Rear A/C Unit In‐
stalled", page 182
❑ Pre-bleed rear cooling
circuit when installing,
refer to
⇒ "9.40 Heater Core,
Removing and Instal‐
ling, Rear A/C Unit In‐
stalled", page 182
moving and installing
rear heater core with
rear heating and A/C
unit installed); and bleed
after installing, refer to
⇒ "7 Coolant Circuit,
Bleeding", page 78
4 - Foam Seal
❑ To rear air channel
5 - Foam Seal
❑ To Rear Air Channel
6 - Right Rear Air Door
❑ Do not remove
7 - Left Rear Air Door
❑ Do not remove
8 - Right Rear Temperature Door
❑ Do not remove
9 - Left Rear Temperature Door
❑ Do not remove
10 - Foam Block
❑ For noise reduction
330
Rep. Gr.87 - Air Conditioning
.
.
(re‐
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.