Rear A/C Unit, Disassembling And Assembling - Audi Q7 2007 Repair Manual

Heating, ventilation and air conditioning
Hide thumbs Also See for Q7 2007:
Table of Contents

Advertisement

❑ For checking functionality, use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
19 - Condensation Water Drain with Valve
❑ For removing and installing, checking, refer to
⇒ "9.54 Rear Condensation Water Drain, Checking, Removing And Installing", page 196
20 - Hose Clamps
21 - Rear A/C Unit
❑ Removing and Installing. Refer to
❑ For bringing into service position, refer to
⇒ "9.39 Rear A/C Unit, Bringing into Service Position", page 180
❑ For disassembling and assembling, refer to
⇒ "20.2 Rear A/C Unit, Disassembling and Assembling", page 329
22 - Left Rear Temperature Door Motor - V313-
❑ With Left Rear Temperature Door Position Sensor - G391-
❑ Removing and Installing. Refer to
⇒ "9.46 Left Rear Temperature Door Motor V313 , Removing and Installing", page 188
23 - Coupling Rod
❑ Mark before removing (risk of interchange)
24 - Rear Fresh Air Blower - V80-
❑ Removing and Installing. Refer to
⇒ "9.41 Rear Fresh Air Blower V80 , Removing and Installing", page 184
❑ To ensure the correct allocation, refer to the Parts Catalog.
❑ For checking functionality, use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
25 - Rear Heater Core
❑ For removing and installing with the A/C unit installed, refer to
⇒ "9.40 Heater Core, Removing and Installing, Rear A/C Unit Installed", page 182
❑ Bonded foam seal, check before installing. Refer to
⇒ "9.40 Heater Core, Removing and Installing, Rear A/C Unit Installed", page 182
❑ Pre-bleed rear cooling circuit when installing, refer to
⇒ "9.40 Heater Core, Removing and Installing, Rear A/C Unit Installed", page 182
rear heater core with rear heating and A/C unit installed); and bleed after installing, refer to
⇒ "7 Coolant Circuit, Bleeding", page 78
26 - Wiring Harness of Rear Heating and A/C Unit
27 - Left Rear Air Door Motor - V239-
❑ With Left Rear Air Door Position Sensor - G389-
❑ Removing and Installing. Refer to
⇒ "9.45 Left Rear Air Door Motor V239 , Removing and Installing", page 187
28 - Left Rear Vent Temperature Sensor - G405-
❑ Installed in rear air duct channel. For removing and installing, refer to
⇒ "9.47 Right Rear Vent Temperature Sensor G406 and Left Rear Vent Temperature Sensor G405 ,
Removing and Installing", page 189
20.2
Rear A/C Unit, Disassembling and As‐
sembling
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
The rear A/C unit is optional equipment and not installed on
all vehicles
For removing and installing the rear A/C unit, refer to
⇒ "19.3 Rear A/C Unit, Removing and Installing", page 325
Heating, Ventilation and Air Conditioning - Edition 04.2013
⇒ "19.3 Rear A/C Unit, Removing and Installing", page 325
.
.
.

20. Rear A/C Unit, Disassembling and Assembling

Audi Q7 2007 ➤
.
.
.
.
.
.
(removing and installing
.
.
.
329

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents