Right Footwell Vent Temperature Sensor G262 , Removing And Installing; Right Footwell Vent Temperature Sensor G262 , Re- Moving And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
9.34 Right Footwell Vent Temperature Sen‐
sor - G262- , Removing and Installing
Note
Only installed on vehicles with a "Comfort" version A/C system
– Remove glove box. Refer to ⇒ Body Interior; Rep. Gr. 68 ;
Storage Compartments and Covers .
– Remove the Front Information Display Control Head Control
Module - J523- / Information Electronics Control Module 1 -
J794- . Refer to ⇒ Communication; Rep. Gr. 91 ; MMI
Infotainment
– Disconnect the connector -B- from the Right Footwell Vent
Temperature Sensor - G262- -A-.
– Rotate the Right Footwell Vent Temperature Sensor - G262-
-A- approximately 90° in direction of arrow.
Note
If there is not enough room to rotate the Right Footwell Vent Tem‐
perature Sensor - G262- -A-, disengage the air channel to right
footwell -E- from the A/C unit (remove the air channel -C- and slide
it slightly downward to the right footwell -E-).
– Remove the Right Footwell Vent Temperature Sensor - G262-
-A- from the air channel to right footwell -E-.
Installing
– Check the O-ring seal -D- for damage and proper fitting.
– Insert the Right Footwell Vent Temperature Sensor - G262-
-A- on proper side into air channel mount -F-.
Note
An O-ring seal -D- is installed so that the Right Footwell Vent
Temperature Sensor - G262- fits without play in mount -F-.
– Connect the connector -B- to the Right Footwell Vent Tem‐
perature Sensor - G262- -A- and check wire routing.
– Install the remaining removed components again in reverse
order.
– Check the DTC memory for the Climatronic control module -
J255- A/C control head and erase any faults displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
168
Rep. Gr.87 - Air Conditioning
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.