Audi Q7 2007 Repair Manual page 104

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
⇒ "12.3 Instrument Panel Vents and Air Ducts in Front (and Rear) Passenger Compartment",
page 209 .
5 - Instrument Panel Vent, Center
❑ For removing and installing instrument panel vents, refer to ⇒ Body Interior; Rep. Gr. 70 ; Front Door
Trim; Air Duct, Removing and Installing .
❑ The amount of outflowing air can be modified separately for driver's and front passenger's side in vehicles
with "Comfort" version A/C system. Refer to
Manual.
6 - Climatronic Control Module - J255- front A/C Control Head of "Basic" Version
❑ Installed only in vehicles with "Basic" version A/C system
❑ Versions vary (for vehicles with or without seat heating. For allocation, refer to the Parts Catalog.)
❑ Removing and Installing. Refer to
⇒ "9.5 Climatronic Control Module J255 Front A/C Control Head Information, Removing and Installing",
page 105 .
❑ Also observe additional notes for the Climatronic Control Module - J255- front A/C control head. Refer
to
⇒ "9.5 Climatronic Control Module J255 Front A/C Control Head Information, Removing and Installing",
page 105 .
❑ On Board Diagnostic (OBD) of the Climatronic Control Module - J255- front A/C control head is to be
performed as described in Guided Fault Finding. Use the Vehicle Diagnostic Tester via the "Guided Fault
Finding" function.
❑ Buttons and display fields are illuminated by light emitting diodes (LED), cannot be replaced.
Note
The Refrigerant Temperature Sen‐
sor - G454- was discontinued as a
running change from 11/2007. If, on
a vehicle with the "Basis" A/C sys‐
tem and without a Refrigerant Tem‐
perature Sensor - G454- , the refrig‐
erant temperature sensor -G454-
displays as a fault, then perform and
adaptation to the front A/C control
head "Basis" (this is not necessary
on the "Comfort" A/C system be‐
cause there are different version of
the front A/C control head). Use the
Vehicle Diagnostic Tester via the
"Guided Fault Finding" function.
7 - Interior Temperature Sensor Fan - V42- and Instrument Panel Temperature Sensor - G56-
❑ Only installed on vehicles with a "Comfort" version A/C system
❑ Installed in "Comfort" version Climatronic Control Module - J255- front A/C control head. Use the Vehicle
Diagnostic Tester via the "Guided Fault Finding" function.
❑ Interior Temperature Sensor Fan - V42- , removing and installing. Refer to
⇒ "9.4 Interior Temperature Sensor Fan V42 , Removing and Installing", page 104
❑ Instrument Panel Temperature Sensor - G56- cannot be replaced individually
8 - Climatronic Control Module - J255- Front A/C Control Head of "Comfort" Version
❑ Only installed on vehicles with a "Comfort" version A/C system
❑ There are different versions (for vehicles without or with seat heating, seat heating with or without seat
ventilation, with an
❑ Removing and Installing. Refer to
⇒ "9.5 Climatronic Control Module J255 Front A/C Control Head Information, Removing and Installing",
page 105 .
❑ Instrument Panel Temperature Sensor - G56- is integrated in the Climatronic Control Module - J255-
front A/C control head (cannot be replaced individually).
❑ The Interior Temperature Sensor Fan - V42- is installed in the Climatronic Control Module - J255- front
A/C control head , however it cannot be replaced individually. Refer to
⇒ "9.4 Interior Temperature Sensor Fan V42 , Removing and Installing", page 104
98
Rep. Gr.87 - Air Conditioning
button or or with a
AC A/C
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
⇒ "12.2 Air Duct in Front A/C Unit", page 206
button). For allocation, refer to the Parts Catalog.
Setup
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
and the Owner's
.
.