Audi Q7 2007 Repair Manual page 149

Heating, ventilation and air conditioning
Hide thumbs Also See for Q7 2007:
Table of Contents

Advertisement

– Install the wiring harness -C- and tighten the mounting points
-B- on the A/C unit.
– Check the wiring harness -C- routing. It must installed so that
it does not make any noise and so that it cannot come in con‐
tact with any moving components.
Note
Secure the wiring harness with additional cable ties and foam
strips to keep it from moving or making noise, if necessary.
– Secure the connector -B- to the A/C unit and then connect the
connector- A-.
– Secure the Auxiliary Heater Heating Element - Z35- ground
connection -C- to the instrument panel crossmember (tighten‐
ing torque: 9 Nm). Refer to Wiring diagrams, Troubleshooting
and Component locations.
– Install the front A/C unit heat exchanger.
♦ For removing and installing the exchanger with the A/C instal‐
led, refer to
⇒ "9.18 Front Heater Core, Removing and Installing, A/C Unit
Installed", page 134
♦ For removing and installing the heat exchanger with the A/C
removed, refer to
⇒ "17.2 Heater Core, Removing and Installing, with Front A/C
Unit Removed", page 303
– Install the instrument panel shell and the glove compartment.
Refer to ⇒ Body Interior; Rep. Gr. 68 ; Storage Compartments
and Covers .
Note
After all the components are installed, except the glove compart‐
ment, check the Auxiliary Heater Heating Element - Z35- control
and function using the A/C and engine control module "control
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
diagnosis" using the Vehicle Diagnostic Tester.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C display control head (and of the Rear A/C
Display Control Head - E265- ) and erase any displayed DTCs.
Use the Vehicle Diagnostic Tester via the "Guided Fault Find‐
ing" function.
– Install the glove compartment. Refer to ⇒ Body Interior; Rep.
Gr. 68 ; Storage Compartments and Covers .
Heating, Ventilation and Air Conditioning - Edition 04.2013
.
.
9. A/C System Control Components Inside Passenger Compartment
Audi Q7 2007 ➤
143

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents