Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
– Disconnect the connector -A-.
Connector Assignment on the High Pressure Sensor - G65-
Terminal -1- ground
Terminal -2- signal output (square wave signal to Climatronic
Control Module - J255- front A/C control head).
Terminal -3 - positive (terminal "75")
Note
With harness connector -B- disconnected, the compressor will
♦
not switch on.
♦
The high pressure sensor -A- is an electronic component,
which creates a square wave signal, the duty cycle ratio
changes with pressure in the refrigerant circuit.
Check the pressure signal from the High Pressure Sensor - G65-
20
Rep. Gr.87 - Air Conditioning
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.