Audi Q7 2007 Repair Manual page 320

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
1 - Air Intake Housing
❑ Do not disassemble fur‐
ther
Note
From 11/2007, the "Comfort" A/C
system as an updated Fresh Air
Blower Control Module - J126- (an
updated "Comfort" Climatronic Con‐
trol Module - J255- and an updated
Fresh Air Blower - V2- ). An updated
air intake housing is also being
used. Make sure to use the correct
allocation for these parts with each
other. Refer to
⇒ "9.31 Fresh Air Blower Control
Module J126 , Removing and Instal‐
ling", page 164
alog.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
2 - Bolt permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3 - Dust and Pollen Filter with
Activated Charcoal Insert
❑ Follow the replacement
intervals. Refer to the
Maintenance Tables.
❑ With an activated char‐
coal filter element. Refer
to the Parts Catalog.
❑ Removing and Instal‐
ling. Refer to
⇒ "9.35 Dust and Pollen
Filter, Removing and In‐
stalling", page 169
Note
An Air Quality Sensor - J255- is also
installed on vehicles with a "Com‐
fort" version Climatronic Control
Module - G238- front A/C control
head.
4 - Dust and Pollen Filter Shaft Cover
❑ Located in vehicle behind footwell lining in front passenger's footwell (below on A/C unit)
❑ Removing and Installing. Refer to
5 - Cover for Right Heater Core
❑ Removing and Installing. Refer to
⇒ "9.24 Right Heater Core Covers, Removing and Installing, Front A/C Unit Installed", page 156
6 - Cover for Heater Core at Bottom
❑ Cover is removed and installed with the heater core
❑ For removing and installing with the A/C unit installed, refer to
⇒ "9.18 Front Heater Core, Removing and Installing, A/C Unit Installed", page 134
❑ For removing and installing with the A/C unit removed, refer to
⇒ "17.2 Heater Core, Removing and Installing, with Front A/C Unit Removed", page 303
7 - Retaining Pin for Cover for Heater Core At Bottom
❑ For removing and installing, for example, with A/C unit removed, refer to
⇒ "17.2 Heater Core, Removing and Installing, with Front A/C Unit Removed", page 303
314
Rep. Gr.87 - Air Conditioning
and to the Parts Cat‐
.
⇒ "9.35 Dust and Pollen Filter, Removing and Installing", page 169 .
.
.
.
.