Left Footwell Vent Temperature Sensor G261 , Removing And Installing - Audi Q7 2007 Repair Manual

– Disengage the connector catches -D- by pressing retaining
tabs -F- and disconnect the connector.
– Wait 30 seconds (to protect electronics in the Climatronic Con‐
trol Module - J255- front A/C control head ).
– Disengage the connector -E- and disconnect it.
– Disengage the catches of connectors -A- to -C- by pressing
retaining tabs -F- and disconnect them.
Note
This illustration shows connectors on a Climatronic Control Mod‐
ule - J255- front A/C control head "Comfort" version with optional
equipment "heated seats". On the "Basic" version, connectors
-A- and -C- are not present, on vehicles without "heated seats" as
optional equipment, connector -E- is not present.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
9.5.5 Climatronic Control Module - J255-
with respect to the correctness of information in this document. Copyright by AUDI AG.
Front A/C Control Head, Installing
– Check the clips -B- and -C- on the Climatronic Control Module
- J255- front A/C control head.
0
Note
Only install a Climatronic Control Module - J255- front A/C control
head -A- on which clips -C- (form-fitting clips with an angle of ap‐
proximately 65°) are installed on upper side and clips -B- on lower
side, otherwise front A/C control head can only be removed again
when the instrument panel center section has been removed
(clips -C- cannot be released on the lower side).
Install the Climatronic Control Module - J255- front A/C control
head (install in reverse order).
– Perform basic setting, encoding, adaptation (and final control
diagnosis, if necessary) for the A/C system. Use the Vehicle
Diagnostic Tester via the "Guided Fault Finding" function.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C control head (and of the Rear A/C Display
Control Head - E265- , if present) and erase DTCs displayed
if necessary. Use the Vehicle Diagnostic Tester via the "Gui‐
ded Fault Finding" function.
9.6 Left Footwell Vent Temperature Sensor
- G261- , Removing and Installing
Note
Only installed on vehicles with a "Comfort" version A/C system
Removing
– Remove lower left instrument panel trim: Refer to ⇒ Body In‐
terior; Rep. Gr. 70 .
Heating, Ventilation and Air Conditioning - Edition 04.2013
9. A/C System Control Components Inside Passenger Compartment
Audi Q7 2007 ➤
111