Audi Q7 2007 Repair Manual page 160

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
tion"). Use the Vehicle Diagnostic Tester via the "Guided Fault
Finding" function.
– As soon as control motors are located in service position,
switch ignition off. Use the Vehicle Diagnostic Tester via the
"Guided Fault Finding" function.
Note
The control motors can only be re-installed in the service position
after removal.
– Remove the lower right instrument panel trim. Refer to ⇒ Body
Interior; Rep. Gr. 70 ; Instrument Panel; Instrument Panel,
Removing and Installing .
– Remove the glove box. Refer to ⇒ Body Interior; Rep. Gr. 68 ;
Storage Compartments and Covers .
– Remove the Front Information Display Control Head Control
Module - J523- / Information Electronics Control Module 1 -
J794- . Refer to ⇒ Communication; Rep. Gr. 91 ; MMI
Infotainment
– Remove the air channel for air duct in front passenger's foot‐
well.
– Remove the right cover from the heater core. Refer to
⇒ "9.24 Right Heater Core Covers, Removing and Installing,
Front A/C Unit Installed", page 156
Note
The bolts -A- are installed underneath the retaining plate -B- for
the control motor.
– Remove the bolts -A-.
Note
The bolts -C- are not loosened or removed to remove retaining
plate -B-, they are used to guide the retaining plate.
– Pull out the retaining plate -B- with control motors downward.
– Mark the connectors -D- and -E- (risk of interchange) and dis‐
connect them.
– Disengage the mount for wiring harness -F- from the retaining
plate -B-.
Installing
154
Rep. Gr.87 - Air Conditioning
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.