Audi Q7 2007 Repair Manual page 185

operated, three lines appear in both displays), settings can then only be modified via the Climatronic
Control Module - J255- front A/C control head and the MMI terminal. Refer to the Owner's Manual.
❑ Also observe additional notes for the Rear A/C Display Control Head - E265- . Refer to
⇒ "9.48 Rear A/C Display Control Head E265 , Removing and Installing", page 190
❑ The Guided Fault Finding of the Climatronic Control Module - E265- A/C control head is to be performed
as described in Guided Fault Finding. Use the Vehicle Diagnostic Tester via the "Guided Fault Finding"
function.
❑ The buttons and display fields are illuminated by light emitting diodes (LED), cannot be replaced.
❑ From MY 2010, the Climatronic Control Module - E265- front A/C control head with part number 4L0
919,158 from index "AA" will be installed as a running change. Refer to the Parts Catalog.
Note
When replacing the Rear A/C
♦
Display Control Head - E265- ,
pay attention to the correct allo‐
cation of the Climatronic Control
Module - J255- front A/C control
head (for example, with or with‐
out the
Setup
location is incorrect, it will not be
possible to display and select
several functions on the A/C sys‐
tem.
In MY 2013, running changes to
♦
the A/C control head were intro‐
duced (for example, recogniza‐
ble by the labeling on the button
instead of
A/C
tronic control module -J255- ).
Pay attention to the correct allo‐
cation (part number 4L0 820 043
through index "AM" with the but‐
ton and from index "AN" with
AC
the button
A/C
vehicles with an additional Rear
A/C Display Control Head -
E265- to use the correct alloca‐
tion of these two components
with each other. Refer to Parts
Catalog.
20 - Vent In Center Console, Rear (Rear Upper Body Vent)
❑ For removing and installing, refer to
⇒ "9.49 Rear Center Console Vents, Removing and Installing", page 191
70 .
❑ Different oncoming flow (vent is supplied with air from front A/C unit in vehicles without rear A/C unit,
from rear A/C unit in vehicles with rear A/C unit)
21 - Left B-Pillar/Footwell Shut-Off Door Motor - V212-
❑ Removing and Installing. Refer to
⇒ "9.50 Left B-Pillar/Footwell Shut-Off Door Motor V212 , Removing and Installing", page 192
❑ The Left B-Pillar/Footwell Shut-Off Door Motor Position Sensor - G329- is installed in the Left B-Pillar/
Footwell Shut-Off Door Motor - V212- .
22 - Left Rear Upper Body Vent Motor - V315-
❑ Removing and Installing. Refer to
⇒ "9.51 Left Rear Upper Body Vent Motor V315 , Removing and Installing", page 192
❑ The Left Rear Upper Body Vent Position Sensor - G471- is installed in the Left Rear Upper Body Vent
Motor - V315- .
23 - Right Rear Upper Body Vent Motor - V316-
❑ Removing and Installing. Refer to
⇒ "9.52 Right Rear Upper Body Vent Motor V316 , Removing and Installing", page 194
Heating, Ventilation and Air Conditioning - Edition 04.2013
button). If the al‐
on the clima‐
AC
). Make sure on
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
9. A/C System Control Components Inside Passenger Compartment
Audi Q7 2007 ➤
.
and ⇒ Body Interior; Rep. Gr.
.
.
.
179