Audi Q7 2007 Repair Manual page 128

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
– Remove the bolts -E- from the Left Center Vent Motor - V110-
-C- and remove the control motor.
– Disconnect the connector -G- from the control motor -C-.
Note
If necessary, mark the connectors (same version on all control
♦
motors) and control motors (for the different versions, refer to
the Parts Catalog) if it is no longer desirable to remove only
one control motor.
The Left Center Vent Motor - V110- -C- is present only on ve‐
♦
hicles with a "Comfort" version A/C system.
Installing
– Connect the connector -G- to the control motor -C-.
– Insert the stud on the Left Center Vent Motor - V110- -C- lever
into guiding groove of lever on center vent door -F-.
Note
Item -H- shows the respective adjustment range of the control
motors.
Remove the control motor on retaining plate.
– Install the removed components again in reverse order.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C control head and erase DTCs displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
– Perform basic setting (and final control diagnosis, if necessa‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
ry) on the A/C system. Use the Vehicle Diagnostic Tester via
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
the "Guided Fault Finding" function. with respect to the correctness of information in this document. Copyright by AUDI AG.
9.13.2 Left Center Vent Motor - V110- - instru‐
ment panel installed, removing and in‐
stalling
122
Rep. Gr.87 - Air Conditioning