Audi Q7 2007 Repair Manual page 130

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
– Mark the control motors if necessary (versions vary. Refer to
the Parts Catalog).
– Remove the bolts -E- from the Left Center Vent Motor - V110-
-C- and remove the control motor.
Installing
Remove the control motor on retaining plate.
– Install retaining plate -D- with control motors -V107- , -V299-
and -V110-
⇒ "9.15 Retaining plate with Defroster Door Motor V107 , Left
Side Vent Motor V299 (and Left Center Vent Motor V110 ),
Removing and Installing", page 128
Note
Check the lever position of the control motors before installing
retaining plate, the retaining plate can only be installed correctly
when it is located in the service position. Refer to
⇒ "9.15 Retaining plate with Defroster Door Motor V107 , Left Side
Vent Motor V299 (and Left Center Vent Motor V110 ), Removing
and Installing", page 128
– Install the removed components again in reverse order.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C control head and erase DTCs displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
– Perform basic setting (and final control diagnosis, if necessa‐
ry) on the A/C system. Use the Vehicle Diagnostic Tester via
the "Guided Fault Finding" function.
124
Rep. Gr.87 - Air Conditioning
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.