Audi Q7 2007 Repair Manual page 50

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
1 - Sealing cap
2 - Drive Plate
❑ Replacing
❑ Attached to the A/C
compressor input shaft
Note
The thread of the new drive plate
has already been greased with a
specific amount of a grease by the
manufacturer.
❑ different versions. Refer
to the Parts Catalog.
❑ the overload protection
takes over when the tor‐
que is excessive (for ex‐
ample, if the A/C com‐
pressor runs with resist‐
ance) and the belt pulley
runs freely without driv‐
ing the A/C compressor.
❑ With rubber elements
for decoupling belt pul‐
ley from A/C compres‐
sor input, dampens ra‐
tions and noise.
❑ Removing and Instal‐
ling. Refer to
⇒ "4.7 Belt Pulley on A/
C Compressor, Remov‐
ing and Installing, Ver‐
sion 3 ", page 45
❑ 30 Nm
3 - Circlip
❑ Replacing
❑ Install on the proper side - the flat side faces A/C compressor
4 - Belt pulley
❑ different versions. Refer to the Parts Catalog.
❑ Made of plastic and is sensitive to impact
❑ Removing and Installing. Refer to
⇒ "4.7 Belt Pulley on A/C Compressor, Removing and Installing, Version 3 ", page 45
5 - A/C compressor
❑ Clean the A/C compressor driveshaft before setting the belt pulley on it
44
Rep. Gr.87 - Air Conditioning
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.