Audi Q7 2007 Repair Manual page 161

– Check the levers of both control motors -A- and -B-, retaining
plate can only be installed correctly when they are located in
the position depicted (service position).
Note
Item -E- shows the respective adjustment range of the control
♦
motors.
If both control motor levers are not located in the position de‐
♦
picted, the control motor(s) may be connected via a 5A fuse
to a 12 V battery, for example, using an adapter lead (refer to
⇒ "9.11 Preparing Adapter Cables for Control Motor Actua‐
tion", page 117 ) (or an adapter lead from the Connector Test
Set - VAG1594/C- to terminals "5" and "6"). Rotate the control
motor for only as long until it has reached the position depicted
(the turning direction can be reversed by switching positive
and negative).
– Check position of threaded plates -G-.
Note
The bolts -F- are used as a guide when installing retaining plate,
if they are screwed in too far, the retaining plate cannot be instal‐
led, if they are not screwed in far enough, it may possibly cause
noise.
– Connect the connectors to control motors (note the assign‐
ment, risk of interchange).
– Insert the retaining plate on to bolts -F-, when doing this make
sure that studs on levers of control motors -A- and -B- are gui‐
ded into lever guides on doors -C- and -D-.
– Slide the retaining plate -B- with control motors on to the A/C
unit from below.
– Check position of bolts -C- and their fit in retaining plate guides
(if retaining plate fits too loosely on bolts -C-, screw them in if
necessary far enough that there is no longer any play--do not
tighten).
– Check the routing of electrical wire and make sure while in‐
stalling that the wires do not come into contact with moving
parts of the control motors and door levers.
– Install the bolts -A-.
– Install the remaining removed components again in reverse
order.
– Check the DTC memory for the Climatronic control module -
J255- A/C control head and erase any faults displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– If necessary, perform a basic setting and output diagnostic test
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
mode on the A/C system. Use the Vehicle Diagnostic Tester
with respect to the correctness of information in this document. Copyright by AUDI AG.
via the "Guided Fault Finding" function.
Heating, Ventilation and Air Conditioning - Edition 04.2013
9. A/C System Control Components Inside Passenger Compartment
Audi Q7 2007 ➤
155