Right Rear Temperature Door Motor V314 , Removing And Installing; Right Rear Air Door Motor V240 , Removing And Installing; Right Rear Air Door Motor V240 , Removing And Instal- Ling - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
9.43 Right Rear Temperature Door Motor -
V314- , Removing and Installing
Note
With the Right Rear Temperature Door Position Sensor - G392-
Removing
– Switch off ignition.
– Remove the left side wall trim in luggage compartment. Refer
to ⇒ Body Interior; Rep. Gr. 70 ; Trim; Luggage Compartment
Side Trim Panel, Removing and Installing .
– Remove (unhook) the lever -2- from the Right Rear Temper‐
ature Door Motor - V314- .
– Remove screws -1-.
– Disconnect the connector from the Right Rear Temperature
Door Motor - V314- and remove the control motor.
Installing
– Install the removed components again in reverse order.
– Check DTC memory of the Climatronic Control Module - J255-
front A/C control head (and of Rear A/C Display Control Head
- E265- ) and erase any DTCs displayed. Use the Vehicle Di‐
agnostic Tester via the "Guided Fault Finding" function.
– If necessary, perform a basic setting and output diagnostic test
mode on the A/C system. Use the Vehicle Diagnostic Tester
via the "Guided Fault Finding" function.
9.44 Right Rear Air Door Motor - V240- , Re‐
moving and Installing
Note
With the Right Rear Air Door Position Sensor - G390-
Removing
– Switch off ignition.
– Remove the left side wall trim in luggage compartment. Refer
to ⇒ Body Interior; Rep. Gr. 70 ; Trim; Luggage Compartment
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Side Trim Panel, Removing and Installing . permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
186
Rep. Gr.87 - Air Conditioning