Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
16.6
Compressor Input Shaft, Loosening and
Tightening (Vehicles with 8-Cylinder FSI
Engine)
Note
Extensive preparations are necessary in order to be able to
♦
loosen the compressor driveshaft. Refer to
⇒ "16.4 Compressor, Removing and Installing (Vehicles with
8-Cylinder FSI Engine)", page 283
Driveshaft can also be checked and tightened without opening
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
the refrigerant circuit
⇒ "16.4 Compressor, Removing and Installing (Vehicles with
8-Cylinder FSI Engine)", page 283
pressor).
Input Shaft, Loosening
– Remove the components which prevent access to driveshaft.
Refer to
⇒ "16.4 Compressor, Removing and Installing (Vehicles with
8-Cylinder FSI Engine)", page 283
– Hold compressor driveshaft -A- in place using a wrench and
turn compressor drive unit -B- in direction of arrow -C-.
Note
Do not turn the driveshaft -A- .
♦
Input shaft -A- can be slid into drive wheel through the boot
♦
-E- after loosening threaded connection.
After installing driveshaft -A-, check installation position of
♦
boot -E-.
Input Shaft, Tightening
– Hold compressor driveshaft -A- in place using a wrench and
turn compressor drive unit -B- in direction of arrow -D- (tight‐
ening torque 60 Nm).
– After tightening compressor driveshaft, check installation po‐
sition of boot -E-
16.7
Compressor Input Shaft, Removing and
Installing (Vehicles with 8-Cylinder FSI
Engine)
Removing
– Remove the compressor. Refer to
⇒ "16.4 Compressor, Removing and Installing (Vehicles with
8-Cylinder FSI Engine)", page 283
292
Rep. Gr.87 - Air Conditioning
(removing compressor).
with respect to the correctness of information in this document. Copyright by AUDI AG.
(Removing the A/C com‐
(removing compressor).
.