Retaining Plate With Left Footwell Door Motor V108 And Left Temperature Door Motor V158 , Removing And Installing; Left Temperature Door Motor V158 , Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
Removing
– Remove the retaining plate -C- with control motors -V108- and
-V158- . Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and

Left Temperature Door Motor V158 , Removing and Installing",

page 114 .
– Mark the control motors if necessary (versions vary. Refer to
the Parts Catalog).
– Remove the bolts -D- from the Left Temperature Door Motor -
V158- -B- and remove the control motor.
Installing
Remove the control motor on retaining plate.
– Install the retaining plate -C- with control motors -V108- and -
V158- . Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and
Left Temperature Door Motor V158 , Removing and Installing",
page 114 .
Note
Check the lever position of the control motors before installing
retaining plate, the retaining plate can only be installed correctly
when it is located in the service position. Refer to
⇒ "9.9 Retaining plate with Left Footwell Door Motor V108 and
Left Temperature Door Motor V158 , Removing and Installing",
page 114 .
– Install the removed components again in reverse order.
– Check the DTC memory of the Climatronic Control Module -
J255- front A/C control head and erase DTCs displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
– If necessary, perform a basic setting and output diagnostic test
mode on the A/C system. Use the Vehicle Diagnostic Tester
via the "Guided Fault Finding" function.
9.9 Retaining plate with Left Footwell Door
Motor - V108- and Left Temperature
Door Motor - V158- , Removing and In‐
stalling
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Only installed on vehicles with a "Comfort" version A/C system
♦
On vehicles with a Climatronic Control Module - J255- "Basic"
♦
version front A/C control head, the footwell doors and temper‐
ature doors on left and right sides are operated by one control
motor respectively, it is fastened at right on the A/C unit (both
left and right doors are connected to each other via a shaft,
the control motors are fastened at right on the A/C unit). Refer
to
⇒ "9.23 Retaining Plate with Control Motors V158 ( V159 ) and
V109 ( V108 ), Removing and Installing", page 153
Removing
– Turn the ignition on.
114
Rep. Gr.87 - Air Conditioning
.