Audi Q7 2007 Repair Manual page 337

11 - Air Duct And Distribution Housing
❑ Do not disassemble further
12 - Evaporator
❑ For removing and installing with rear A/C unit installed, refer to
⇒ "19.1 Rear Evaporator, Removing and Installing, A/C Unit Installed", page 321
❑ Check bonded foam seal, it must not be damaged and bonded on.
13 - Foam Seal
❑ Bonded on evaporator
❑ Check, it must not be damaged and must be bonded all around.
14 - Foam Seal
❑ Bonded to evaporator refrigerant pipes.
15 - Bracket for Expansion Valve
16 - O-ring Seal
❑ Replacing. Refer to the Parts Catalog.
❑ Lubricate lightly with refrigerant oil before installing. Refer to
⇒ "3.6 Refrigerant Circuit O-Ring Seals", page 26
17 - O-ring Seal
❑ Replacing. Refer to the Parts Catalog.
❑ Lubricate lightly with refrigerant oil before installing. Refer to
⇒ "3.6 Refrigerant Circuit O-Ring Seals", page 26
18 - Rear Expansion Valve
❑ Removing and Installing. Refer to
⇒ "15.12 Rear Expansion Valve, Removing and Installing ", page 275
❑ To ensure the correct allocation, refer to the Parts Catalog.
❑ For checking functionality, refer to
performance of A/C system).
19 - Bolt
❑ Tightening specification 10 Nm
20 - Evaporator Housing
❑ For removing and installing with rear A/C unit installed, refer to
⇒ "19.1 Rear Evaporator, Removing and Installing, A/C Unit Installed", page 321
21 - Cover
Heating, Ventilation and Air Conditioning - Edition 04.2013
.
.
⇒ "13 A/C Unit, Checking Cooling Output", page 215
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
20. Rear A/C Unit, Disassembling and Assembling
Audi Q7 2007 ➤
.
.
(checking cooling
.
331