Audi Q7 2007 Repair Manual page 154

Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
❑ Control motor, removing and installing. Refer to
⇒ "9.21 Right Temperature Door Motor V159 (or Left Temperature Door Motor V158 ), Removing and
Installing", page 151
11 - Evaporator Vent Temperature Sensor - G263-
❑ Removing and Installing. Refer to
⇒ "9.29 Evaporator Vent Temperature Sensor G263 , Removing and Installing", page 162
12 - Right Footwell Door Motor - V109- (or Left Footwell Door Motor - V108- )
Note
The name for this control motor
♦
depends on the version of the A/
C system (of the Climatronic
Control Module - J255- front A/C
control head), it is different in On
Board Diagnostics (OBD) and in
wiring diagram of "Comfort" ver‐
sion and "Basic" version. Refer
to Wiring diagrams, Trouble‐
shooting and Component loca‐
tions.
On vehicles with a Climatronic
♦
Control Module - J255- front A/C
control head "Basic" version, the
left and right footwell doors are
operated by the Left Footwell
Door Motor - V108- (both left and
right doors are connected to
each other via a shaft respec‐
tively, motor is installed at right
on the A/C unit), control motor is
designated "left" and is fastened
on right side on the A/C unit.
♦ The Right Footwell Door Motor Position Sensor - G140- is installed in Right Footwell Door Motor - V109- .
♦ The Left Footwell Door Motor Position Sensor - V108- is installed in Left Footwell Door Motor - G139- .
❑ For removing and installing the retaining plate with control motors -V158- ( -V159- ) and -V109- ( -V108- ),
refer to
⇒ "9.23 Retaining Plate with Control Motors V158 ( V159 ) and V109 ( V108 ), Removing and Installing",
page 153 .
❑ Control motor, removing and installing. Refer to
⇒ "9.22 Right Footwell Door Motor V109 (or Left Footwell Door Motor V108 ), Removing and Installing",
page 152 .
13 - Hose and Air Duct to Glove Compartment Cooling System
❑ Only present on vehicles with a glove compartment cooling system (optional equipment)
❑ The hose is inserted into the opening
bolt.
❑ Glove compartment, removing. Refer to ⇒ Body Interior; Rep. Gr. 68 ; Storage Compartments and
Covers .
14 - Fresh Air Blower Control Module - J126-
❑ Removing and Installing. Refer to
⇒ "9.31 Fresh Air Blower Control Module J126 , Removing and Installing", page 164
❑ For checking, use the Vehicle Diagnostic Tester via the "Guided Fault Finding" function.
❑ There are different versions for vehicles with and without the parking/auxiliary heater. Refer to the Parts
Catalog.
148
Rep. Gr.87 - Air Conditioning
.
⇒ Item 9 (page 147) and the air guide is attached to the A/C by a
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.