Roadster Inner Door Seal, Removing And Installing; Inner Door Seal - Audi TT 207 Repair Manual

– Then press door seal onto door flange between A-pillar and lower B-pillar, starting at the center and
working out.
– Press door seal on completely between upper and lower A-pillar, beginning at center and working out.
2 - Roof frame seal
❑ Pressed onto flange in roof frame
3 - Roof trim molding

Roadster Inner Door Seal, Removing and Installing

1 - Front seal
Note
❑ Upper A-pillar trim and
roof frame trim re‐
moved. Refer to ⇒ Body
Interior; Rep. Gr. 70 ;
Removal and Installa‐
tion
– Unscrew the screws
and remove the front
seal starting at the »A-
pillar«.
– Remove any adhesive
residue from where the
seal was secured with
adhesive tape.
– Adhesion surfaces must
be free of dust and
grease, clean with
cleaning solution D 009
401 04 -Reinigungslö‐
sung- .
– Attach the seal to the
upper left and right cor‐
ners of the roof flange.
– Slide the seal on the roof
frame
– Attach the seal in a
downward direction on‐
to the flange of the »A-
pillar«.
– Secure the upper seal
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with the left and right screws.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Gradually pull the protective film to the side via the removal tabs out from between the roof frame and
the seal and press the seal onto the roof frame with a roller -3356- .

2 - Inner door seal

❑ Lower A-pillar trim, sill panel, and rear panel trim removed. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Removal and Installation
– Remove the door seal around the body flange and under the front seal.
– Remove any adhesive residue from where the seal was secured with adhesive tape.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
83