Audi Q7 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 04.2013
– Disconnect the connector -B- from the Fresh Air Blower - V2-
-C-.
– Remove the bolts -A-.
– Remove the Fresh Air Blower - V2- -C- downward.
Installing
– Insert the Fresh Air Blower - V2- -C- carefully into the A/C unit
from below.
– Install the remaining removed components again in reverse
order.
– Check the DTC memory for the Climatronic control module -
J255- A/C control head and erase any faults displayed if
necessary. Use the Vehicle Diagnostic Tester via the "Guided
Fault Finding" function.
– If necessary, perform a basic setting and output diagnostic test
mode on the A/C system. Use the Vehicle Diagnostic Tester
via the "Guided Fault Finding" function.
9.31
Fresh Air Blower Control Module -
J126- , Removing and Installing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
164
Rep. Gr.87 - Air Conditioning