Trigger:block:branch:once:excluded - Keithley DMM7510 Reference Manual

7 1/2 digit graphical sampling multimeter

Hide thumbs Also See for DMM7510:

Table of Contents

Section 6: SCPI command reference

The branch-once building block branches to a specified block the first time trigger model execution

encounters the branch-once block. If it is encountered again, the trigger model ignores the block and

continues in the normal sequence.

The once block is reset when trigger model execution reaches the idle state. Therefore, the

branch-once block always executes the first time the trigger model execution encounters this block.

:TRIG:BLOC:BRAN:ONCE 2, 4

The first time the trigger model reaches block 2, the trigger model goes to block 4 instead of proceeding to the

default sequence of block 3.

(on page 3-86)

:TRIGger:BLOCk:BRANch:ONCE:EXCLuded

This command causes the trigger model to go to a specified building block every time the trigger model

encounters it, except for the first time.

Command only

:TRIGger:BLOCk:BRANch:ONCE:EXCLuded <blockNumber>, <branchToBlock>

The branch-once-excluded block is ignored the first time the trigger model encounters it. After the first

encounter, the trigger model goes to the specified branching block.

The branch-once-excluded block is reset when the trigger model starts or is placed in idle.

:TRIG:BLOC:BRAN:ONCE:EXCL 2, 4

When the trigger model reaches block 2 the first time, the trigger model goes to block 3. If the trigger model

reaches this block again, the trigger model goes to block 4.

Once excluded block

:TRIGger:BLOCk:BRANch:ONCE

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

Recall settings

Instrument reset

The sequence of the block in the trigger model

The block number of the trigger model block to execute when the trigger

model encounters this block after the first encounter

(on page 3-87)

(on page 6-189)

(on page 6-190)

Save settings

Default value

Not applicable

DMM7510-901-01 Rev. B / May 2015