Status.preset() - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
When a mapped event is programmed to clear bits, the bit in the condition register is set to 0 when
the event is detected.
If the event is set to zero (0), the bit is never set.
Example
status.operation.setmap(0, 2731, 2732)
Also see
Operation Event Register
Programmable status register sets
status.operation.getmap()

status.preset()

This function resets all bits in the status model.
Type TSP-Link accessible
Function Yes
Usage
status.preset()
Details
This function clears the event registers and the enable registers for operation and questionable. It will
not clear the Service Request Enable Register (*SRE) to Standard Request Enable Register (*ESE).
Preset does not affect the event queue.
The Standard Event Status Register is not affected by this command.
Example
status.preset()
Also see
Status model
DMM7510-901-01 Rev. B / May 2015
(on page 7)
(on page 5)
(on page 8-244)
Affected by
(on page 1)
Section 8: TSP command reference
When event 2731(trigger model initiated)
occurs, bit 0 in the condition and event
registers of the Operation Event Register
are set. When event 2732 (trigger model
idled) occurs, bit 0 in the condition register is
cleared.
Where saved
Resets the instrument status model.
Default value
8-245