Buffervar.units - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

bufferVar.units

This attribute contains the unit of measure that is stored with readings in the reading buffer.
Type TSP-Link accessible
Attribute (R) Yes
Usage
readingUnit = bufferVar.units[N]
readingUnit
bufferVar
N
DMM7510-901-01 Rev. B / May 2015
Affected by Where saved
Restore configuration Not applicable
Instrument reset
Power cycle
Volt DC: DC voltage measurement
Volt AC: AC voltage measurement
Amp DC: DC current measurement
Amp AC: AC current measurement
Ohm: Resistance measurement
Farad: Capacitance measurement
Hertz: Frequency measurement
Second: Period measurement
Ratio: DCV ratio measurement
%: Math is set to percent for the measurements
mX+b: Math is set to mx+b for the measurements
Reciprocal: Math is set to reciprocal for the measurements
Decibel: Units are set to decibel
Celsius: Temperature measurement
Kelvin: Temperature measurement
Fahrenheit: Temperature measurement
Watt DC: Power measurement
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
The reading number N; can be any value from 1 to the number of readings in the
buffer; use the bufferVar.n command to determine the number of readings in the
buffer
Section 8: TSP command reference
Default value
Not applicable
8-41