Keithley DMM7510 Reference Manual page 239

Section 3: Functions and features
SCPI command
TSP command
:DIGital:LINE<n>:MODE
digio.line[N].mode
A line reset is not available in SCPI; however, the line is
reset when a global reset (*RST) is sent
digio.line[N].reset()
:DIGital:LINE<n>:STATe
digio.line[N].state
:DIGital:READ?
digio.readport()
:DIGital:WRITe <n>
digio.writeport()
:TRIGger:DIGital<n>:IN:CLEar
trigger.digin[N].clear()
:TRIGger:DIGital<n>:IN:EDGE
trigger.digin[N].edge
:TRIGger:DIGital<n>:IN:OVERrun?
trigger.digin[N].overrun
Not available in SCPI
trigger.digin[N].wait()
Not available in SCPI
trigger.digout[N].assert()
:TRIGger:DIGital<n>:OUT:LOGic
trigger.digout[N].logic
:TRIGger:DIGital<n>:OUT:PULSewidth
trigger.digout[N].pulsewidth
Not available in SCPI
trigger.digout[N].release()
:TRIGger:DIGital<n>:OUT:STIMulus
trigger.digout[N].stimulus
3-56
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
(on page 6-38)
(on page 8-52)
(on page 8-54)
(on page 6-40)
(on page 8-55)
(on page 6-41)
(on page 8-55)
(on page 6-42)
(on page 8-56)
(on page 6-204)
(on page 8-260)
(on page 6-204)
(on page 8-260)
(on page 6-205)
(on page 8-261)
(on page 8-262)
(on page 8-263)
(on page 6-206)
(on page 8-264)
(on page 6-207) This command describes the length of time that the
(on page 8-264)
(on page 8-265)
(on page 6-208)
(on page 8-266)
Description
This command sets the mode of the digital I/O line to
be a digital line, trigger line, or synchronous line and
sets the line to be input, output, or open-drain.
This command resets digital I/O line values to their
factory defaults.
This command sets a digital I/O line high or low when
the line is set for digital control and returns the state
on the digital I/O lines.
This command reads the digital I/O port. All six lines
must be configured as digital control lines. If not, this
command generates an error.
This command writes to all digital I/O lines. All six
lines must be configured as digital control lines. If not,
this command generates an error.
This command clears the trigger event on a digital
input line.
This command sets the edge used by the trigger
event detector on the given trigger line.
This command returns the event detector overrun
status.
This command waits for a trigger.
This command asserts a trigger pulse on one of the
digital I/O lines.
This command sets the output logic of the trigger
event generator to positive or negative for the
specified line.
trigger line is asserted for output triggers.
This command releases an indefinite length or
latched trigger.
This command selects the event that causes a trigger
to be asserted on the digital output line.
DMM7510-901-01 Rev. B / May 2015