Dmm.digitize.analogtrigger.edge.slope - Keithley DMM7510 Reference Manual

Section 8: TSP command reference

dmm.digitize.analogtrigger.edge.slope

This attribute defines the slope of the analog trigger edge.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = dmm.digitize.leveltrigger.slope
dmm.digitize.leveltrigger.slope = value
value
Functions
dmm.FUNC_DC_VOLTAGE
dmm.FUNC_AC_VOLTAGE
dmm.FUNC_DC_CURRENT
dmm.FUNC_AC_CURRENT
dmm.FUNC_TEMPERATURE
Details
This is only available when the analog trigger mode is set to edge.
Rising causes an analog trigger event when the analog signal trends from below the analog signal
level to above the level.
Falling causes an analog trigger event when the signal trends from above to below the level.
Example
dmm.digitize.func = dmm.FUNC_DIGITIZE_VOLTAGE
dmm.digitize.analogtrigger.mode = dmm.MODE_EDGE
dmm.digitize.analogtrigger.edge.level = 5
dmm.digitize.analogtrigger.edge.slope = dmm.SLOPE_FALLING
Set the function to digitize voltage.
Set the analog trigger mode to edge.
Set the level to sense 5 V.
Set the level to be detected on a falling edge.
Also see
Analog triggering overview
dmm.digitize.analogtrigger.edge.level
dmm.digitize.analogtrigger.mode
dmm.digitize.func
dmm.measure.analogtrigger.edge.slope
8-72
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by
Restore configuration
Instrument reset
Power cycle
Measure configuration list
Rising: dmm.SLOPE_RISING
Falling: dmm.SLOPE_FALLING
dmm.FUNC_RESISTANCE
dmm.FUNC_4W_RESISTANCE
dmm.FUNC_DIODE
dmm.FUNC_CAPACITANCE
dmm.FUNC_CONTINUITY
(on page 3-64)
(on page 8-71)
(on page 8-74)
(on page 8-90)
(on page 8-119)
Where saved Default value
Configuration script dmm.SLOPE_RISING
Measure configuration list
dmm.FUNC_ACV_FREQUENCY
dmm.FUNC_ACV_PERIOD
dmm.FUNC_DCV_RATIO
dmm.FUNC_DIGITIZE_CURRENT
dmm.FUNC_DIGITIZE_VOLTAGE
DMM7510-901-01 Rev. B / May 2015