Trigger.digout[N].Stimulus - Keithley DMM7510 Reference Manual

Section 8: TSP command reference

trigger.digout[N].stimulus

This attribute selects the event that causes a trigger to be asserted on the digital output line.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
event = trigger.digout[N].stimulus
trigger.digout[N].stimulus = event
event
N
Details
The digital trigger pulsewidth command determines how long the trigger is asserted.
The trigger stimulus for a digital I/O line can be set to one of the trigger events that are described in
the following table.
Trigger events
Event description
No trigger event
Front-panel TRIGGER key press
Notify trigger block N (1 to 8) generates a trigger event when
the trigger model executes it
A command interface trigger (bus trigger):
•
Any remote interface: *TRG
•
GPIB only: GET bus command
•
VXI-11: VXI-11 command device_trigger
Line edge (either rising, falling, or either based on the
configuration of the line) detected on digital input line N
(1 to 6)
Line edge detected on TSP-Link synchronization line N
(1 to 3)
Appropriate LXI trigger packet is received on LAN trigger
object N (1 to 8)
8-266
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by Where saved
Restore configuration Configuration script
Instrument reset
Power cycle
Digital I/O trigger N reset
The event to use as a stimulus; see Details
Digital I/O trigger line (1 to 6)
Default value
trigger.EVENT_NONE
Event constant
trigger.EVENT_NONE
trigger.EVENT_DISPLAY
trigger.EVENT_NOTIFYN
trigger.EVENT_COMMAND
trigger.EVENT_DIGION
trigger.EVENT_TSPLINKN
trigger.EVENT_LANN
DMM7510-901-01 Rev. B / May 2015