[:Sense[1]]:<Function>:Threshold:range:auto - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
[:SENSe[1]]:<function>:THReshold:RANGe:AUTO
This command determines if the threshold range is set manually or automatically.
Type
Command and query
Usage
[:SENSe[1]]:<function>:THReshold:RANGe:AUTO <state>
[:SENSe[1]]:<function>:THReshold:RANGe:AUTO?
<function>
<state>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
This command determines how the range is selected.
When this command is set to off, you must set the range. If you do not set the range, the instrument
remains at the range that was selected by autorange.
When this command is set to on, the instrument uses the signal to determine the most sensitive
range on which to perform the measurement. The instrument sets the range when a measurement is
requested. To set the range, the instrument makes a measurement to determine the range before
making the final measurement, which can result in slower reading times. Turn autorange off and set a
specific range to increase measure time.
If a range is manually selected through the front panel or a remote command, this command is
automatically set to off.
Example
:FUNC "FREQ"
:FREQ:THR:RANG:AUTO OFF
:FREQ:THR:RANG 10
Also see
[:SENSe[1]]:<function>:THReshold:LEVel
[:SENSe[1]]:<function>:THReshold:RANGe
DMM7510-901-01 Rev. B / May 2015
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which the setting applies; see Functions
The auto range setting:
•
Disable: OFF or 0
•
Enable: ON or 1
RESistance
FRESistance
DIODe
CAPacitance
(on page 6-109)
(on page 6-110)
Where saved
Save settings
Measure configuration list
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
Set measure function to frequency.
Disable the threshold autorange.
Set the range to 10 V.
Section 6: SCPI command reference
Default value
ON (1)
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent
6-111