[:Sense[1]]:<Function>:Average[:State] - Keithley DMM7510 Reference Manual

Section 6: SCPI command reference
Example 3
VOLT:AVER:COUNT 10
VOLT:AVER:TCON MOV
VOLT:AVER ON
Also see
Filtering measurement data
[:SENSe[1]]:<function>:AVERage[:STATe]
[:SENSe[1]]:<function>:AVERage:TCONtrol
[:SENSe[1]]:<function>:AVERage[:STATe]
This command enables or disables the averaging filter for measurements of the selected function.
Type
Command and query
Usage
[:SENSe[1]]:<function>:AVERage[:STATe] <state>
[:SENSe[1]]:<function>:AVERage[:STATe]?
<function>
<state>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
This command enables or disables the averaging filter. When this is enabled, the reading returned by
the instrument is an averaged value, taken from multiple measurements. The settings of the filter
count and filter type for the selected measure function determines how the reading is averaged.
6-68
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
(on page 3-11)
(on page 6-68)
(on page 6-69)
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which the setting applies; see Functions
The filter status; set to one of the following values:
•
Disable the averaging filter: OFF or 0
•
Enable the averaging filter: ON or 1
RESistance
FRESistance
DIODe
CAPacitance
For voltage measurements, set the averaging
filter type to moving average, with a filter count of
10.
Enable the averaging filter.
Where saved
Save settings
Measure configuration list
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
DMM7510-901-01 Rev. B / May 2015
Default value
OFF (0)
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent