Trigger:timer<N>:Start:overrun - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
:TRIGger:TIMer<n>:STARt:OVERrun?
This command indicates if an event was ignored because of the event detector state.
Type
Query only
Usage
:TRIGger:TIMer<n>:STARt:OVERrun?
<n>
Details
This command indicates if an event was ignored because the event detector was already in the
detected state when the event occurred.
This is an indication of the state of the event detector built into the timer itself. It does not indicate if
an overrun occurred in any other part of the trigger model or in any other construct that is monitoring
the delay completion event. It also is not an indication of a delay overrun.
This returns 0 if there is no overrun or 1 if there is an overrun.
Example
TRIG:TIM1:STAR:OVER?
Also see
None
DMM7510-901-01 Rev. B / May 2015
Affected by
Not applicable
Trigger timer number (1 to 4)
Section 6: SCPI command reference
Where saved
Not applicable
Checks the overrun status on trigger timer 1.
Default value
Not applicable
6-239