[:Sense[1]]:Digitize:count - Keithley DMM7510 Reference Manual

Section 6: SCPI command reference
Example
:TRAC:CLEAR
:COUN 10
:MEAS?
:TRAC:DATA? 1,10
Also see
:MEASure? (on page 6-4)
:TRACe:DATA?
:TRIGger:LOAD "SimpleLoop"

[:SENSe[1]]:DIGitize:COUNt

This command sets the number of measurements to digitize when a measurement is requested.
Type
Command and query
Usage
[:SENSe[1]]:DIGitize:COUNt <n>
[:SENSe[1]]:DIGitize:COUNt DEFault
[:SENSe[1]]:DIGitize:COUNt MINimum
[:SENSe[1]]:DIGitize:COUNt MAXimum
[:SENSe[1]]:DIGitize:COUNt?
[:SENSe[1]]:DIGitize:COUNt? DEFault
[:SENSe[1]]:DIGitize:COUNt? MINimum
[:SENSe[1]]:DIGitize:COUNt? MAXimum
<n>
Details
The digitizer makes the number of readings set by this command in the time set by the sample rate.
This command does not affect the trigger model.
Example
DIG:COUN 10
Also see
:MEASure:DIGitize?
6-122
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
(on page 6-155)
(on page 6-231)
Affected by
Recall settings
Instrument reset
Power cycle
The number of measurements (1 to 55,000,000)
(on page 6-7)
Clear data from the reading buffer.
Set the count to 10.
Make ten measurements.
Returns the last measurement.
Example output:
-5.693831E-05
Read all ten measurements.
Example output:
-7.681046E-05,-2.200288E-04,-
9.086048E-05,-6.388056E-05,-
7.212282E-05,-4.874761E-05,-
4.741654E-04,-6.811028E-05,-
5.110232E-05,-5.693831E-05
Where saved
Save settings
Make ten measurements.
DMM7510-901-01 Rev. B / May 2015
Default value
10,000