[:Sense[1]]:<Function>:Thermistor - Keithley DMM7510 Reference Manual

Section 6: SCPI command reference
[:SENSe[1]]:<function>:THERmistor
This command describes the type of thermistor.
Type
Command and query
Usage
[:SENSe[1]]:<function>:THERmistor <n>
[:SENSe[1]]:<function>:THERmistor DEFault
[:SENSe[1]]:<function>:THERmistor MINimum
[:SENSe[1]]:<function>:THERmistor MAXimum
[:SENSe[1]]:<function>:THERmistor?
[:SENSe[1]]:<function>:THERmistor? DEFault
[:SENSe[1]]:<function>:THERmistor? MINimum
[:SENSe[1]]:<function>:THERmistor? MAXimum
<function>
<n>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
This command is only applicable when the transducer type is set to thermistor.
For the <n> parameter, only 2252, 5000, or 10000 are valid entries. Other values you enter will cause
an out of range error message. The only exception to this is if you enter 2200 or 2250, the Model
DMM7510 will accept the entry but change it to 2252.
Example
FUNC "TEMP"
TEMP:TRAN THER
TEMP:THER 2252
Also see
[:SENSe[1]]:<function>:TRANsducer
Temperature measurements
6-108
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which the setting applies; see Functions
The thermistor type in ohms:
•
2252: 2252
•
5000: 5000
•
10000: 10000
RESistance
FRESistance
DIODe
CAPacitance
(on page 6-112)
(on page 2-120)
Where saved
Save settings
Measure configuration list
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
Set measurement function to temperature.
Set the transducer type to thermistor.
Set the thermistor type to 2252.
DMM7510-901-01 Rev. B / May 2015
Default value
5000
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent