Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Example
TRACe:STAT:STDDev?
TRACe:STAT:STDDev? "testData"
Also see
Reading buffers
Remote buffer operation
:TRACe:MAKE
:TRACe:STATistics:CLEar
:TRACe:STATistics:MAXimum?
:TRACe:STATistics:MINimum?
:TRACe:STATistics:PK2Pk?
:TRACe:TRIGger
This command makes readings using the active measure function and stores them in a reading buffer.
Type
Command only
Usage
:TRACe:TRIGger
:TRACe:TRIGger "<bufferName>"
<bufferName>
Details
A measure function must be selected before sending this command.
This command makes the number of measurements that is set by the count command.
Example
TRACe:MAKE "MyBuffer", 100
COUN 5
TRACe:TRIG "MyBuffer"
TRACe:DATA? 1,5, "MyBuffer", rel
Also see
[:SENSe[1]]:COUNt
[:SENSe[1]]:FUNCtion[:ON]
:TRACe:MAKE
DMM7510-901-01 Rev. B / May 2015
(on page 3-13)
(on page 3-30)
(on page 6-160)
(on page 6-167)
(on page 6-168)
(on page 6-169)
(on page 6-170)
Affected by
Not applicable
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-defined buffer; if no
buffer is specified, defbuffer1 is used
(on page 6-121)
(on page 6-124)
(on page 6-160)
Returns the standard deviation of the readings in the
default buffer defbuffer1.
Returns the standard deviation of the readings in the
user-defined buffer testData.
Where saved
Not applicable
Create a buffer called MyBuffer with a maximum size of
100.
Make readings and store them in MyBuffer.
Recall the relative time when the data points were measured
for the first five readings in the buffer.
Example output:
0.000000,0.408402,0.816757,1.208823,1.617529
Section 6: SCPI command reference
Default value
Not applicable
6-171