[:Sense[1]]:Trigger:digitize:stimulus - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

[:SENSe[1]]:TRIGger:DIGitize:STIMulus

This command sets the instrument to digitize a measurement the next time it detects the specified trigger event.
Type
Command and query
Usage
[:SENSe[1]]:TRIGger:DIGitize:STIMulus <event>
[:SENSe[1]]:TRIGger:DIGitize:STIMulus?
<event>
Details
This command is intended to provide the lowest possible latency between a trigger event such as
digital I/O and a reading. It forces the instrument to make a digitize measurement the next time it
detects the specified trigger event. Options for the trigger event parameter are listed in the following
table.
A digitize function must be active before sending this command. The measurement is digitized for the
active function. If a measure function is active, an error is generated.
Before using this command, set the active reading buffer. Readings are stored in the active reading
buffer.
If the count is set to more than 1, the first reading is initialized by this trigger. Subsequent readings
occur as rapidly as the instrument can make them. If a trigger occurs during the group measurement,
the trigger is latched and another group of measurements with the same count will be triggered after
the current group completes.
If the stimulus is set to none, this command has no effect on readings.
DMM7510-901-01 Rev. B / May 2015
Affected by
Recall settings
Instrument reset
Power cycle
The event to use as a stimulus; see Details
Section 6: SCPI command reference
Where saved
Save settings
Default value
NONE
6-125