Tspnet.reset(); Tspnet.termination() - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

tspnet.reset()

This function disconnects all TSP-Net sessions.
Type TSP-Link accessible
Function No
Usage
tspnet.reset()
Details
This command disconnects all remote instruments connected through TSP-Net. For TSP-enabled
devices, this causes any commands or scripts running remotely to be terminated.
Also see
None

tspnet.termination()

This function sets the device line termination sequence.
Type TSP-Link accessible
Function No
Usage
type = tspnet.termination(connectionID)
type = tspnet.termination(connectionID, termSequence)
type
connectionID
termSequence
Details
This function sets and gets the termination character sequence that is used to indicate the end of a
line for a TSP-Net connection.
Using the termSequence parameter sets the termination sequence. The present termination
sequence is always returned.
For the termSequence parameter, use the same values listed in the table above for type. There are
four possible combinations, all of which are made up of line feeds (LF or 0x10) and carriage returns
(CR or 0x13). For TSP-enabled devices, the default is tspnet.TERM_LF. For devices that are not
TSP-enabled, the default is tspnet.TERM_CRLF.
DMM7510-901-01 Rev. B / May 2015
Affected by Where saved
Affected by Where saved
The termination type:
•
tspnet.TERM_LF
•
tspnet.TERM_CR
•
tspnet.TERM_CRLF
•
tspnet.TERM_LFCR
The connection ID returned from tspnet.connect()
The termination sequence:
•
tspnet.TERM_LF
•
tspnet.TERM_CR
•
tspnet.TERM_CRLF
•
tspnet.TERM_LFCR
Section 8: TSP command reference
Default value
Default value
8-359