Keithley DMM7510 Reference Manual page 551

Section 6: SCPI command reference
<limitxHigh>
<limitxLow>
<limit1Pattern>
<limit2Pattern>
<limit3Pattern>
<limit4Pattern>
<allPattern>
<bufferName>
Details
This trigger model template allows you to grade components and place them into up to four bins,
based on the comparison to limits.
To set a limit as unused, set the high value for the limit to be less than the low limit.
All limit patterns and the pass pattern are sent on digital I/O lines 1 to 4, where 1 is the least
significant bit.
The out line of the EXT TRIG IN/OUT rear-panel terminal is asserted at the end of each
measurement.
After selecting a trigger model template, you can view the trigger model blocks in a graphical format
by pressing the front-panel MENU key and under Trigger, selecting Configure. You can also add or
delete blocks and change trigger model settings from this screen. You can use the
TRIGger:BLOCk:LIST? command to view the trigger model blocks in a list format.
Example
For a detailed example, see the section in the Model DMM7510 User's Manual named "Grading and
binning resistors."
Also see
None
6-224
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
x is limit 1, 2, 3, or 4; the upper limit that the measurement is compared
against
x is 1, 2, 3, or 4; the lower limit that the measurement is compared against
The bit pattern that is sent when the measurement fails limit 1; range 1 to
15; default is 1
The bit pattern that is sent when the measurement fails limit 2; range 1 to
15; default is 2
The bit pattern that is sent when the measurement fails limit 3; range 1 to
15; default is 4
The bit pattern that is sent when the measurement fails limit 4; range 1 to
15; default is 8
The bit pattern that is sent when all limits have passed; 1 to 15; default
is 15
A string that indicates the reading buffer; the default buffers (defbuffer1
or defbuffer2) or the name of a user-defined buffer; if no buffer is
specified, defbuffer1 is used
DMM7510-901-01 Rev. B / May 2015