[:Sense[1]]:<Function>:Detector:bandwidth - Keithley DMM7510 Reference Manual

Section 6: SCPI command reference
[:SENSe[1]]:<function>:DETector:BANDwidth
This command selects the detector bandwidth for AC current and AC voltage measurements.
Type
Command and query
Usage
[:SENSe[1]]:<function>:DETector:BANDwidth <n>
[:SENSe[1]]:<function>:DETector:BANDwidth DEFault
[:SENSe[1]]:<function>:DETector:BANDwidth MINimum
[:SENSe[1]]:<function>:DETector:BANDwidth MAXimum
[:SENSe[1]]:<function>:DETector:BANDwidth?
[:SENSe[1]]:<function>:DETector:BANDwidth? DEFault
[:SENSe[1]]:<function>:DETector:BANDwidth? MINimum
[:SENSe[1]]:<function>:DETector:BANDwidth? MAXimum
<function>
<n>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
You can set the detector bandwidth to improve measurement accuracy. Select the bandwidth that
contains the lowest frequency component of the input signal. For example, if the lowest frequency
component of your input signal is 40 Hz, use a bandwidth setting of 30 Hz.
If the bandwidth is set to 3 Hz or 30 Hz, the autozero feature is always enabled and the integration
rate is fixed.
Example
FUNC "VOLT:AC"
VOLT:AC:DET:BAND 30
Also see
[:SENSe[1]]:<function>:APERture
[:SENSe[1]]:<function>:AZERo[:STATe]
[:SENSe[1]]:<function>:NPLCycles
[:SENSe[1]]:AZERo:ONCE
6-82
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which the setting applies; see Functions
3 Hz, 30 Hz, or 300 Hz
RESistance
FRESistance
DIODe
CAPacitance
(on page 6-53)
(on page 6-72)
(on page 6-85)
(on page 6-114)
Where saved
Save settings
Measure configuration list
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
Set the measure function to AC volts.
Set the detector bandwidth for AC volts to 30 Hz.
DMM7510-901-01 Rev. B / May 2015
Default value
30
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent