Section 2: General operation
The number of displayed digits does not affect accuracy or speed. It also does not affect the format of
readings that are returned from a remote command.
From the front panel:
1. Press MENU.
2. Under Measure, select Settings.
3. Next to Display Digits, select the number of digits to display.
This setting takes effect the next time you make a measurement.
From a remote interface:
•
SCPI commands: Refer to
•
TSP commands: For measure functions, refer to
digitize functions, refer to
Setting the display format
You can set the format of units that are displayed for measurement readings on the front panel. The
formats are:
•
Prefix: Add a prefix to the units symbol, such as k, m, or µ
•
Exponent: Replace the units symbol with exponents
See the following figures for examples of each display format.
2-56
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
:DISPlay:<function>:DIGits
dmm.digitize.displaydigits
Figure 27: Model DMM7510 prefix display format
(on page 6-43).
dmm.measure.displaydigits
(on page 8-89).
DMM7510-901-01 Rev. B / May 2015
(on page 8-148). For