Dmm.digitize.analogtrigger.pulse.width - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

dmm.digitize.analogtrigger.pulse.width

This attribute defines the threshold value for the pulse width.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = dmm.digitize.analogtrigger.pulse.width
dmm.digitize.analogtrigger.pulse.width = value
value
Details
This option is only available when the analog trigger mode is set to pulse.
This option sets either the minimum or maximum pulse width that generates an analog trigger event.
The value of pulse condition determines whether this value is interpreted as the minimum or
maximum pulse width.
Example
dmm.digitize.func = dmm.FUNC_DIGITIZE_VOLTAGE
dmm.digitize.analogtrigger.mode = dmm.MODE_PULSE
dmm.digitize.analogtrigger.pulse.level = 5
dmm.digitize.analogtrigger.pulse.width = 30e-6
dmm.digitize.analogtrigger.pulse.condition = dmm.CONDITION_LESS
dmm.digitize.analogtrigger.pulse.polarity = dmm.POLARITY_BELOW
Set function to digitize voltage.
Set the analog trigger mode to pulse.
Set the analog trigger level to 5 V.
Set the analog trigger pulse width to 30 µs.
Set the condition to be detect trigger within the pulse width.
Set the trigger to occur when the pulse is below the level.
Also see
Analog triggering overview
dmm.digitize.analogtrigger.mode
dmm.digitize.func
dmm.digitize.analogtrigger.pulse.condition
dmm.digitize.analogtrigger.pulse.level
dmm.digitize.analogtrigger.pulse.polarity
dmm.measure.analogtrigger.pulse.width
DMM7510-901-01 Rev. B / May 2015
Affected by
Restore configuration
Instrument reset
Power cycle
Measure configuration list
The threshold value for the pulse width: 1 µs to 40 ms
(on page 3-64)
(on page 8-74)
(on page 8-90)
(on page 8-76)
(on page 8-77)
(on page 8-78)
(on page 8-126)
Section 8: TSP command reference
Where saved Default value
Configuration script 1 ms
Measure configuration list
8-79