[:Sense[1]]:<Function>:Tcouple:type - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
[:SENSe[1]]:<function>:TCouple:TYPE
This command indicates the thermocouple type.
Type
Command and query
Usage
[:SENSe[1]]:<function>:TCouple:TYPE <identifier>
[:SENSe[1]]:<function>:TCouple:TYPE?
<function>
<identifier>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
This command is only applicable when the transducer type is set to thermocouple.
Example
TEMP:TRAN TC
TEMP:TC:TYPE K
TEMP:UNIT C
TEMP:TC:RJUN:SIM 30
Also see
[:SENSe[1]]:<function>:TCouple:RJUNction:SIMulated
[:SENSe[1]]:<function>:TRANsducer
Temperature measurements
DMM7510-901-01 Rev. B / May 2015
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The function to which the setting applies; see Functions
B, E, J, K, N R, S, or T
RESistance
FRESistance
DIODe
CAPacitance
(on page 6-112)
(on page 2-120)
Where saved
Save settings
Measure configuration list
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
Set the transducer type to thermocouple.
Set the thermocouple type to K.
Set the units to Celsius.
Set the simulated reference temperature to 30.
(on page 6-106)
Section 6: SCPI command reference
Default value
K
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent
6-107