[:Sense[1]]:Count - Keithley DMM7510 Reference Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual

[:SENSe[1]]:COUNt

This command sets the number of measurements to make when a measurement is requested.
Type
Command and query
Usage
[:SENSe[1]]:COUNt <n>
[:SENSe[1]]:COUNt DEFault
[:SENSe[1]]:COUNt MINimum
[:SENSe[1]]:COUNt MAXimum
[:SENSe[1]]:COUNt?
[:SENSe[1]]:COUNt? DEFault
[:SENSe[1]]:COUNt? MINimum
[:SENSe[1]]:COUNt? MAXimum
<n>
Functions
VOLTage[:DC]
VOLTage:AC
CURRent[:DC]
CURRent:AC
Details
This command sets the number of measurements that are made when a measurement is requested.
This command does not affect the trigger model.
This command sets the count for all measure functions.
If you set the count to a value that is larger than the capacity of the reading buffer and the buffer fill
mode is set to continuous, the buffer wraps until the number of readings specified have occurred. The
earliest readings in the count are overwritten. If the buffer is set to fill once, readings stop when the
buffer is filled, even if the count is not complete.
To get better performance from the instrument, use the Simple Loop trigger model template instead
of using the count command.
DMM7510-901-01 Rev. B / May 2015
Affected by
Recall settings
Instrument reset
Power cycle
The number of measurements (1 to 1,000,000)
RESistance
FRESistance
DIODe
CAPacitance
Where saved
Save settings
TEMPerature
CONTinuity
FREQuency[:VOLTage]
PERiod[:VOLTage]
Section 6: SCPI command reference
Default value
1
VOLTage[:DC]:RATio
DIGitize:VOLTage
DIGitize:CURRent
6-121