Status.operation.enable - Keithley DMM7510 Reference Manual

Section 8: TSP command reference

status.operation.enable

This attribute sets or reads the contents of the Operation Event Enable Register of the status model.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
operationRegister = status.operation.enable
status.operation.enable = operationRegister
operationRegister
Details
This command sets or reads the contents of the Enable register of the Operation Event Register.
When one of these bits is set, when the corresponding bit in the Operation Event Register or
Operation Condition Register is set, the OSB bit in the Status Byte Register is set.
Example
-- decimal 20480 = binary 0101 0000 0000 0000
status.operation.enable = operationRegister
Also see
Operation Event Register
Understanding bit settings
8-242
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by Where saved
status.preset() Nonvolatile memory
The status of the operation status register
(on page 7)
(on page 14)
Default value
0
Sets the 12 and 14 bits of the operation
status enable register using a decimal
value.
DMM7510-901-01 Rev. B / May 2015