Trace:trigger:digitize - Keithley DMM7510 Reference Manual

Section 6: SCPI command reference

:TRACe:TRIGger:DIGitize

This command makes readings using the active digitize function and stores them in the reading buffer.
Type
Command only
Usage
:TRACe:TRIGger:DIGitize
:TRACe:TRIGger:DIGitize "<bufferName>"
<bufferName>
Details
A digitize function must be selected before sending this command.
This command makes the number of digitize measurements that is set by the digitize count
command.
Example
DIG:FUNC "VOLTage"
TRACe:MAKE "MyBuffer", 100
TRACe:TRIG:DIG "MyBuffer"
TRACe:TRIG:DIG "MyBuffer"
TRACe:TRIG:DIG "MyBuffer"
TRACe:TRIG:DIG "MyBuffer"
TRACe:TRIG:DIG "MyBuffer"
TRACe:DATA? 1,5, "MyBuffer", rel
Also see
[:SENSe[1]]:DIGitize:COUNt
[:SENSe[1]]:DIGitize:FUNCtion[:ON]
:TRACe:MAKE
6-172
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
Affected by
Not applicable
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-defined buffer; if no
buffer is specified, defbuffer1 is used
(on page 6-122)
(on page 6-123)
(on page 6-160)
Where saved
Not applicable
Make the digitize voltage measurement function the active
function.
Create a buffer called MyBuffer with a maximum size of 100.
Make readings and store them in MyBuffer.
Recall the relative time when the data points were measured
for the first five readings in the buffer.
Example output:
0.000000,0.408402,0.816757,1.208823,1.617529
Default value
Not applicable
DMM7510-901-01 Rev. B / May 2015