ABB DressPack IRB6650S Product Manual page 85

9
10
11
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
2.2.6.2 Fitting the cable packages IRBDP MH2 LE and IRBDP SW2 LE
Action
Attach the cable bracket with the attachment
screws M6x16 quality 8.8-A2F (2 pcs).
Lock screws with locking liquid.
Spot welding applications only:
Run the weld power cable slightly to the right
of the signal cables and hoses in order to
make it easier to connect the cables in the
robot base.
Fit the weld power cable to the bracket with
its two attachment screws.
Spot welding applications only:
Fit the weld power cable to the rear of the
process plate with two attachment screws,
using the weld connector bracket.
Do not tighten the attachment screws at this
point!
Screws are supplied with the kit.
© Copyright 2004-2018 ABB. All rights reserved.
2 Installation
Note
Art. no. is specified in Required equip-
ment on page 81.
xx0500001421
Parts:
• A: Cable bracket
• B: Attachment screws M6x16,
quality 8.8-A2F (2 pcs)
Check that the weld power cable does
not end up between other cables and
hoses!
C
F
A
B
xx0300000196
Parts (as seen from above):
• A: Weld power cable (behind pro-
cess plate)
• B: Weld connector bracket
• C: Process plate
• D: Screw holes in process plate
• E: Attachment screws M6x30
quality 8.8-A2F (2 pcs)
• F: Guide pins on weld connector
bracket
Continues on next page
Continued
B
A
D
E
85