ABB DressPack IRB6650S Product Manual page 309

5
Refitting the protection hose
Refit the back part protection hose
1
2
3
4
5
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
4.2.15 Replacing the protection hose - IRBDP SW6 UI and MH6 UI
Action
Carefully pull the cables and hoses out and re-
move the back end of the protection hose.
Tip
The following order is preferred:
1 Cables with small connectors
2 Hoses
3 Cables with large connectors
Action
DANGER
Turn off all:
• electric power supply
• air pressure supply
to the robot, before starting the repair work on the
robot.
Cut the new protection hose, back part, to the
length required.
Note
Place the cut on top of a ridge.
Put some cable grease on cables and hoses on
the area where they run through the protection
hose and hose reinforcement funnel.
Carefully push cables and hoses into the protec-
tion hose.
Tip
The following order is preferred:
1 Cables with large connectors
2 Hoses
3 Cables with small connectors
Make sure that cables and hoses are not twisted.
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
Continued
Note
Note
A
xx0300000061
A Top of a ridge
Length: 500 mm
Continues on next page
309