ABB DressPack IRB6650S Product Manual page 339

Required equipment
Equipment
Water and Air unit
Standard toolkit,
DressPack/SpotPack
Circuit diagram
Removal
The procedure below details how to remove the water-in circuit. It does not deal
with details specific to each version, such as article numbers, connector types etc.
For details see the Spare parts section.
1
2
3
4
5
6
7
8
Refitting
The procedure below details how to refit the water-in circuit. It does not deal with
details specific to each version, such as article numbers, connector types etc. For
details see the Spare parts section.
1
2
3
4
5
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
Art. no.
See Spare parts sec-
tion!
3HAC17290-7
3HAC026208-001
Action
Turn off the water supply to the Water and Air unit.
Remove the hose of the water supply of the work-
shop to the Water-in circuit.
Remove the Proc 2 hose from the Water and Air
unit.
Remove the Pushlok nipple.
Loosen the locking nut.
Unscrew the two attachment screws holding the
water-in circuit.
Remove the Water-in circuit from the mounting
plate.
Remove the DIN-connector from the electrical water
valve.
Action
Attach the DIN-connector to the electrical water
valve.
Fit the water-in circuit with its two attachment
screws on the mounting plate.
Tighten the locking nut.
Fit the Pushlok nipple.
Connect the Proc 2 hose on the Water and Air unit.
CAUTION
Do not tighten the brass couplings for water and air
with excessive force.
© Copyright 2004-2018 ABB. All rights reserved.
4.4.2 Replacement of Water-in circuit
Note
A number of versions are available.
The Water and Air unit assembly con-
tains all required hardware for fitting
and connecting.
The contents are defined in section
Toolkits, DressPack/SpotPack on
page 355.
SpotPack
Note
Note
Tightening torque, brass coup-
lings 1/2": 31 Nm
Continues on next page
4 Repair
Continued
339