ABB DressPack IRB6650S Product Manual page 140

2 Installation
2.2.9.3 Fitting the cable package IRBDP SW6 LE and IRBDP MH6 UI and SW6 UI, LeanID
Continued
Connect the cable package
1
Weld connector
Only valid for IRBDP SW6 UI.
1
2
Continues on next page
140
Action
Connect the hose and cable connectors on the
connection plate.
CAUTION
Do not tighten the brass couplings for water and
air with excessive force.
Tip
Start connecting top connectors, and continue
downwards, ending with Proc 4.
Action
Press (manually) the cables with the crimped-on
contact part into the insulation from the back until
it perceptibly engages into place to the detent.
Note
Make sure the pins are pushed all the way into
the connector.
Fit the cable strain relief.
xx1300000836
© Copyright 2004-2018 ABB. All rights reserved.
Note
Tightening torque, brass couplings
1/2": 31Nm
Tightening torque, brass couplings
3/8": 17Nm
xx1200000059
Note
xx1400000216
xx1200000058
Screw, M5x25 8.8-A2F (2 pcs)
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C