ABB DressPack IRB6650S Product Manual page 175

2
3
Process cable package too short
If the DressPack is too short, unacceptable strain may be put on the cables, hoses
and connectors.
1
2
3
4
5
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
2.3.1 Adjustments of - IRBDP MH2 UE and IRBDP SW2 UE
Action
Loop the excess hoses and cables in a way
that enables securing them with cable
clamps or similar allowing quick replace-
ment of the package.
After changing the DressPack upper arm
installation, it needs to be inspected to en-
sure the function.
Action
Make sure the correct cable package is
used.
Note
Remember that different lengths of the up-
per arm require different cable packages!
Check that the position of the ball joint
housing is correct.
Make sure all attachments and supports
are fitted correctly.
Note
If the DressPack cable package appears to
be fitted too strained, the reason can be
that the tension arm is adjusted too tightly.
After changing the DressPack upper arm
installation, it needs to be inspected to en-
sure the function.
© Copyright 2004-2018 ABB. All rights reserved.
2 Installation
Note
When securing cables and hoses with
cable ties: never overtighten the ties! This
may damage the equipment.
Note
Use wide cable ties!
Detailed in section Adjustments of - IRB-
DP MH2 UE and IRBDP SW2 UE on
page 172.
Note
Check the Adjustments of - IRBDP MH2
UE and IRBDP SW2 UE on page 172
tion for article numbers!
Detailed in section Adjustments of - IRB-
DP MH2 UE and IRBDP SW2 UE on
page 172.
If required adjust their fitting positions!
When securing cables and hoses with
cable ties: never overtighten the ties! This
may damage the equipment.
How to adjust the tension arm is detailed
in section Adjusting tension arm unit on
page 320.
Detailed in section Preventive inspection,
DressPack upper arm on page
Continued
sec-
212.
175